Skip to main content

Back to ekwb.com

Submit a request

EKWB Support Center
Troubleshooting
EK Connect

Articles in this section

My EK-Loop Connect is returning the message, "A controller communication error was detected, please restart the application." What should I do?
What does the Smart D-RGB setting do?
What is a safe flow rate value?
How can I adjust the offset for the EK Loop Connect Flow Meter?
How can I adjust the offset for the temperature sensors T1, T2, and T3?
How do I rename a component?
How do I set a fan/pump curve?
My controller isn't being detected, what can I do?
I am getting a blank user interface, what is wrong?
Where are my settings stored?

See more

Can I use the EK Loop Connect in Linux or MAC OS?

Eva

June 03, 2021 13:53
Updated

Unfortunately, this is not possible, only Windows 10 is supported.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Related articles

I have my temperature source set to one of the temperature sensors (T1, T2, T3) and after my computer wakes from sleep, the temperature source switches to CPU, what is wrong?
My controller isn't being detected, what can I do?
Can I use the F6 pump header for fans?
What temperature sources can I use to control the fans and pump?
The PWM settings don't have any effect on the actual fan/pump speed, what is wrong?

Comments

0 comments

Article is closed for comments.

EKWB Support Center